Tesla is facing issues with the bare metal construction of the Cybertruck, which Elon Musk warned was as tricky to do as making Lego bricks
Tesla is facing issues with the bare metal construction of the Cybertruck, which Elon Musk warned was as tricky to do as making Lego bricks
deleted by creator
He’s probably hyper self conscious about people ripping into Teslas over their clearances (with inconsistencies measured in millimetres). But, no, instead of saying “VW can produce stuff that doesn’t look like it fell from a truck and you will figure it out, too” he’s going overboard.
If we’re going overboard, why bother with cars at all? Just use this cheesy blueprint, make it work and solve all of humanity’s problems! This is what California should invest in instead of trains.
Elon: “Stacking” tolerances? No, we will not tolerate anything less than micron precision on every aspect of the design.
Micron, as in 0.00004"? Yes you COULD hold it, with second ops and temp control.
deleted by creator
The total tolerance is .0004". In equally disposed bilateral tolerancing it will be ±.0002".
Eh, if someone tells me to reduce a tolerance from 5 to 10 thou at work, it’s understood that it’s +/-5 and 10. I don’t think I’ve ever heard someone use the full range of a tolerance in conversation. If the tolerance isn’t bilateral, it would be said like plus 5, minus zero. Anyways, +/- .0005" is our standard tolerance on the span of all dowel hole pairs.
Bilateral tolerancing is a Machinist’s first introduction to tolerancing so it’s no surprise to run that as default. And I suppose GD&T is not heavily used where you are.
If you’re given a parallelism tolerance of 10 micron are you assuming that to be ±10 micron? True position? Angularity of 5 thou? Etc… The only feature control that could be interpreted as bilateral by default is profile and it’s still communicated by its total tolerance.
Simple ± tolerancing isn’t the industry standard anymore. And if Tesla prints are anything like spaceX ones… It’s basically all GD&T and minimal title block tolerances.
I use GD&T on all my drawings, including 100% of my hole callouts. However I’m one of the more enthusiastic adopters of ASME Y14.5 at the place I work. Therefore, I get what your saying regarding the tolerance range, but since most of my coworkers are still relying on block tolerances, I’ll refer to a .010" positional tolerance as a “+/- .005” equivalent" in conversation so there is no miscommunication. I can see how this is not the norm.
deleted by creator
Just curious… what does Starrett have that Tesla will need?
Starrett isn’t known for quality precision metrology.
deleted by creator