Need to expand local storage for local media streaming. Running a regular desktop on linux.

I am willing to spend money on “the best” for streaming purpose while and hopefully something I can keep reusing down the road if it lasts.

  • shadow@lemmy.sdf.org
    link
    fedilink
    English
    arrow-up
    4
    ·
    7 days ago

    I just grabbed a pair of 18TB Seagate Exos SATA drives - surprisingly quiet for what they are.

      • IronKrill@lemmy.ca
        link
        fedilink
        English
        arrow-up
        3
        ·
        edit-2
        7 days ago

        IMO, yes. HDDs are always going to be a bit noisy, but the consumer grades keep it fairly classy. The couple of HGST drives I got from ServerPartDeals are noisy in the “grating” way. The volume is similar but the noise is not in the normal pleasant range. I am only fine with it because my server is in another room.

      • mumblerfish@lemmy.world
        link
        fedilink
        English
        arrow-up
        1
        ·
        7 days ago

        I recently got some Toshibas and they were loud. They also presented with a seek error pre-fail after a few days (all three of them). That propably adds to the volume, but the seagate and wds I switched to just have some clicking noises. Not too bad.

      • Drathro@dormi.zone
        link
        fedilink
        English
        arrow-up
        5
        ·
        7 days ago

        In my experience, Seagate exos are only “loud/clicky” when under HEAVY write loads. Mostly they’re pretty quiet with a very low drone at worst. In any decent case it’ll be pretty negligible. With headphones on doubly so.

        • shadow@lemmy.sdf.org
          link
          fedilink
          English
          arrow-up
          2
          ·
          7 days ago

          This is my experience. I had them on my desk in a test bay to make sure they were all good to go and the only time I notice them is when they’re doing a lot of read/write movements. While they idle they’re quiet. So it depends on your use case, where the drive physically is, and what the drive is attached to. If it’s mounted with nice rubber dampers or something you might never hear them. If they’re mounted up to a loose chunk of metal they might rattle and drive you nuts.